BATTERY BUDDY INSTRUCTIONS HOW TO
BATTERY BUDDY INSTRUCTIONS INSTALL
BATTERY BUDDY INSTRUCTIONS FREE

If a lithium-ion battery is discharged below 2.5 volts per cell, a safety circuit built into the battery opens and the battery appears to be dead to the end user. Avoid completely discharging lithium-ion batteries!.In short all of these things affect how quickly stress breaks down (oxidizes) the internal cell structure of the battery. As an overview: elevated temperature and high currents affect cycle life, and Lithium-ion suffers from stress when exposed to heat or keeping a cell at a high charge voltage.

BATTERY BUDDY INSTRUCTIONS HOW TO

We highly encourage you to please take care of your Batteries! How to Care for Your Battery:ĭid you know that compared to a FULL discharge, a partial discharge reduces stress and prolongs battery life? Our batteries are Lithium-Ion rechargeable batteries, and normal care for Li-Ion devices applies to our batteries as well. Also, Lithium-ion batteries suffer from stress when exposed to heat, as does keeping a cell at a high charge voltage. Please remember that elevated temperature and high currents affect battery cycle life. Please especially note that the LED will flash and auto power off if you hold the button to draw current for longer than 8 seconds, this is to prevent overheat!įully discharging your battery may harm it until it eventually appears to be dead (once it reaches a point below 2.5v it will no longer charge with our chargers)! It is much better to do a partial discharge as this reduces stress and prolongs battery life. If battery is fully discharged the voltage will drop below where it can be charged and the LED will flash but the pen will no longer work. FIVE (5) button clicks will turn on the the pen’s battery power, five clicks again to turn off.We highly recommend the Green setting as it will prolong the battery life and reduce the heat used to vaporize the contents of the cartridge Red is 4.0 Volts, Blue is 3.8 Volts, Green is 3.6 Volts THREE (3) button clicks will select the variable voltage as follows:.TWO (2) button clicks will preheat the contents of the cartridge simply let this cycle to the end (indicated by color cycling) or press the button to begin vaporization.ONE (1) button click to engage power and vaporize the cartridge contents!.Replace the phillips screw on the side of the unit.Reinstall the buttons if they came loose. Close the Golf Buddy back up, making sure not to crimp the screen ribbon cable.Put the motherboard back into place while making sure not to crimp the wires.

BATTERY BUDDY INSTRUCTIONS INSTALL

Plug in and install the new Golf Buddy Voice Battery.

(Look at the connector of the new battery You will see the OEM battery located underneath.

Carefully lift the motherboard from the back half of the case.

If it does become detached, it can be reattached later, but it's easier if you Screen is attached to the motherboard by a ribbon cable near the top. Do not take the two halves of the case apart completely (open the case very carefully like you would a clamshell, from the bottom side opening upwards). Place the screw in a safe location for reassembly later.Īround the seam.

Remove the #00 Phillips screw on the side of the unit (next to the on/off switch).

Them in with a finger to keep them from coming off.

First note where each of the buttons on the Golf Buddy are positioned as they will most likely come off during the replacement process and you will need to put each one back in the right spot.

BATTERY BUDDY INSTRUCTIONS FREE

Note: Above tools are included FREE when this replacement battery is purchased from MPF Products.

YK372731 Battery for Golf Buddy Voice GPS Rangefinder.

Battery buddy instructions